Leggett & Platt SIMPLICITY HFMS 2.0 SPLIT TOP Mode D'emploi page 3

REMOTE CONTROL PROGRAMMING - 1 OR 2 REMOTES TO OPERATE 1 BASE
Simultaneously press and hold the HEAD
1
1 UP and FOOT DOWN buttons on remote
control 1 until the remote control backlight
flashes, then release.
FLAT
HEAD 1
UP
HEAD 1 HEAD 2
FOOT
MASSAGE
4
Operate remote control 1 to verify the
base functions correctly.
2 Unplug the base from the power
outlet. Wait 3 minutes, then plug
base back into power outlet. YOU
HAVE 1 MINUTE TO COMPLETE
STEP 3.
FOOT
AN ELECTRICAL SURGE PROTECTION
DOWN
DEVICE IS RECOMMENDED (NOT INCLUDED).
5
To program remote 2, wait 15 seconds
after remote 1 was last used, then repeat
steps 1-3 on remote control 2.
3 MINUTES
NOTE
Simultaneously press and hold the
3
HEAD 1 DOWN and FOOT UP buttons
on remote control 1 until the remote
control backlight flashes, then release.
FLAT
HEAD 1 HEAD 2
FOOT
HEAD 1
DOWN
MASSAGE
6
Operate remote control 2 to verify the
base functions correctly.
NOTE
WAIT 15 SECONDS WHEN SWITCHING
BETWEEN OPERATING REMOTE 1 AND
REMOTE 2.
FOOT
UP
3