Publicité
Les langues disponibles
Les langues disponibles
Press to adjust the base to the factory default ZG position. To
reprogram, adjust the base, massage, and underbed light to
the desired position, press and hold the FLASHLIGHT button
for 6 second (remote control backlight will flash), then press
the ZG button within 2 seconds. The adjustable bed will beep
Press to adjust the base to the factory default snore position.
To reprogram, adjust the base, massage, and underbed light to
the desired position, press and hold the FLASHLIGHT button
for 6 second (remote control backlight will flash), then press
the SNORE button within 2 seconds. The adjustable bed will
Press to turn flashlight ON for 15 seconds.
Press and hold to raise or lower the head 1 section.
HEAD MASSAGE INCREASE BUTTON
Press to turn on head massage. Press again to
increase massage intensity. Massage turns off
HEAD MASSAGE DECREASE BUTTON
Once head massage is turned ON, press to decrease massage
intensity. Once massage is at the lowest intensity, press again
Press to turn massage on in wave mode. Press
again to cycle through wave speeds.
REMOTE CONTROL REQUIRES (2) AAA SIZE BATTERIES. TO CONSERVE BATTERY LIFE, THE TRANSMITTER
To put the remote control in "press and hold" mode simultaneously press and hold the FLAT and FLASHLIGHT buttons
for 3 seconds. Remote backlight will flash 3 times, confirming the change. Your base is now set to "Press & Hold" mode.
To revert back to "press and release" mode, simultaneously press and hold the LOCK and FLASHLIGHT buttons for 3
seconds. Remote backlight will flash once, confirming the change. Your base is now set to "Press and Release" mode.
2
REMOTE CONTROL FUNCTION
ZG (ZERO GRAVITY) BUTTON
confirming this change.
SNORE BUTTON
beep confirming this change.
FLASH LIGHT BUTTON
HEAD 1 UP/DOWN BUTTON
automatically after 15 minutes.
to turn massage OFF.
WAVE BUTTON
TURNS OFF ALL FUNCTIONS WHEN ANY BUTTON IS PRESSED FOR MORE THAN 50 SECONDS.
"PRESS & HOLD" MODE:
"PRESS & RELEASE" MODE:
NOTE: THIS ACTION WILL ALSO RESET MEMORY POSITIONS TO FACTORY DEFAULT SETTINGS.
LOCK BUTTON
To lock / unlock the remote control buttons, press and hold
LOCK button for 5 seconds. Backlight will flash 3 times.
UNDERBED LIGHT BUTTON
Press to turn on/off underbed light feature.
M1 BUTTON
Press to adjust the base to the factory default memory position.
To reprogram, adjust the base, massage, and underbed light to
the desired position, press and hold the FLASHLIGHT button
for 6 second (remote control backlight will flash), then press
the M1 button within 2 seconds. The adjustable bed will beep
confirming this change.
FLAT BUTTON
FLAT
Press to lower the base to the level position.
This button also turns off massagers.
FOOT UP/DOWN BUTTON
Press and hold to raise or lower the foot section.
HEAD 1
HEAD 2
HEAD 2 UP/DOWN BUTTON
FOOT
Press and hold to raise or lower the head 2 section.
MASSAGE
FOOT MASSAGE INCREASE BUTTON
Press to turn on foot massage. Press again to increase massage
intensity. Massage turns off automatically after 15 minutes.
FOOT MASSAGE DECREASE BUTTON
Once foot massage is turned ON, press to decrease massage
intensity. Once massage is at the lowest intensity, press again
to turn massage OFF.
MASSAGE ON/OFF BUTTON
Press to turn massage motors ON or OFF.
NOTE
Publicité
