Topaz ARL-150PCS-T3 Instructions D'installation page 5

Item:
ARL-150PCS-T3 ARL-150PCS-T4
ARL-300PCS-T3 ARL-300PCS-T4
ARL-480PCS-T3 ARL-480PCS-T5
ARL-150PCS-T5-HV ARL-300PCS-T3-HV
ARL-480PCS-T3-HV ARL-480PCS-T5-HV
ARL-300PCS-SWO
LED AREA LIGHT POWER & CCT SELECTABLE
INSTALLATION INSTRUCTIONS
Tool-less Lens Change For Switchable Optics (SWO) only:
Figure 19
Figure 21
Instructions For Installing Motion Sensor:
Figure 23
Figure 24
**NOTE: THESE INSTRUCTIONS DO NOT ADDRESS ALL PERMUTATIONS THAT MAY EXIST IN INSTALLATION, MAINTENANCE, AND OPERATING ENVIRONMENT.
**REMARQUE : CES INSTRUCTIONS NE TRAITENT PAS DE TOUTES LES PERMUTATIONS QUI PEUVENT EXISTER DANS L'INSTALLATION, LA MAINTENANCE ET L'ENVIRONNEMENT D'EXPLOITATION.
**NOTA: ESTAS INSTRUCCIONES NO ABORDAN TODAS LAS PERMUTACIONES QUE PUEDEN EXISTIR EN EL ENTORNO DE INSTALACIÓN, MANTENIMIENTO Y OPERACIÓN.
www.topaz-usa.com | 800.666.2852 | ©2023 Southwire Company, LLC. All rights reserved.
ARL-150PCS-T5
ARL-300PCS-T5
ARL-150PCS-T3-HV
ARL-300PCS-T5-HV
ARL-150PCS-SWO
Figure 20
Figure 22
Fixture
Plug
Fixture
Motion Sensor
1. Open the 2 spring latches located at the top of the
lens then swing open the lens frame. See Figure 19.
2. Remove the stock lens. See Figure 20.
3. Insert the new lens. See Figure 21.
4. Close the lens frame and close the spring latches.
The fixture is ready to be installed. See Figure 22.
Note: Type 3 Lens pre-Installed. Type II, IV and V
included.
1. Remove the plug from the sensor socket. Insert the
motion sensor into the socket. See Figure 23.
2. Twist the motion sensor clockwise until snug. Do
not over tighten. See Figure 24.