Topaz ARL-150PCS-T3 Instructions D'installation

Item:
ARL-150PCS-T3 ARL-150PCS-T4
ARL-300PCS-T3 ARL-300PCS-T4
ARL-480PCS-T3 ARL-480PCS-T5
ARL-150PCS-T5-HV ARL-300PCS-T3-HV
ARL-480PCS-T3-HV ARL-480PCS-T5-HV
ARL-300PCS-SWO
LED AREA LIGHT POWER & CCT SELECTABLE
INSTALLATION INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS!
Make all electrical and ground connections in accordance with local codes or the National

Electrical Code. If you are not familiar with these codes and requirements, consult a
qualified electrician. This Professional should be familiar with the construction and
operation of this product and hazards involved. Failure to do so may result in serious
personal injury.
To reduce the risk of fire, electric shock, personal injury, or property damage, please read

and follow all safety instructions. If you do not understand these instructions or if any
additional information is required, contact your local Topaz representative. Retain these
instructions for maintenance reference.
Do not exceed the allowed supply voltage marked on the luminaire label information.

Disconnect power at the circuit breaker panel before any installation.

Do not expose wire to any sharp objects such as sheet metal to prevent wiring damage or

abrasion.
While the light is on, please avoid direct eye exposure.

Combustible material should be kept away from fixture/LENS.

Do not make or alter any open holes in any enclosure or any electrical component during

installation.
Do not use when the enclosure is damaged or broken in any way.

Do not alter, relocate or remove wiring, lamp holder power supply or any other electrical

component.
Pursuant to NEC 410.69, "Effective January 1, 2022, where control conductors are spliced,

terminated, or connected in the same luminaire or enclosure as the branch-circuit
conductors, the field-connected control conductor shall not be of a color reserved for the
grounded branch circuit conductor or the equipment grounding conductor." And NEC
200.6(A)(2), "An insulated grounded conductor of 6 AWG or smaller shall be identified by
one of the following means: (2) The insulated conductor shall have a continuous gray outer
finish." For this reason, Topaz® will be transitioning from using Purple and Gray dimming
wires, to Purple and Pink dimming wires.
www.topaz-usa.com | 800.666.2852 | ©2023 Southwire Company, LLC. All rights reserved.
ARL-150PCS-T5
ARL-300PCS-T5
ARL-150PCS-T3-HV
ARL-300PCS-T5-HV
ARL-150PCS-SWO
WARNING
CAUTION