Topaz ARL-150PCS-T3 Instructions D'installation page 4

Item:
ARL-150PCS-T3 ARL-150PCS-T4
ARL-300PCS-T3 ARL-300PCS-T4
ARL-480PCS-T3 ARL-480PCS-T5
ARL-150PCS-T5-HV ARL-300PCS-T3-HV
ARL-480PCS-T3-HV ARL-480PCS-T5-HV
ARL-300PCS-SWO
LED AREA LIGHT POWER & CCT SELECTABLE
INSTALLATION INSTRUCTIONS
4. Direct Pole Mounting:
Mount
Supply
Base
Wire
Mounting
Plate
Figure 15
Supply Wires
Wiring Compartment Lid
Square
Pole
Figure 17
Wiring Diagram:
Black: ACL
Green:
White: ACN
www.topaz-usa.com | 800.666.2852 | ©2023 Southwire Company, LLC. All rights reserved.
ARL-150PCS-T5
ARL-300PCS-T5
ARL-150PCS-T3-HV
ARL-300PCS-T5-HV
ARL-150PCS-SWO
Direct Pole
Fixture
Mount
Bolts
Figure 16
Round
Pole
Rounded Silicon
Plate
Figure 18
Purple:Dim+
Pink:Dim-
1. Install the mount base to the pole using the mounting
plate. Then route the supply wire through the mounting
plate and the mount base. See Figure 15.
Note: For round pole, remove the rounded silicon plate. See
Figure 18.
2. Attach the fixture to the mount base by installing 2 bolts
and make wiring connections according to the Wiring
Diagram below. See Figure16 .
3. Push excess wire into the pole and close the wiring
compartment lid. See Figure 17.
1. Make sure AC power is turned off before beginning any
electrical work.
2. Connect input wires Black to line, White to neutral, Green
to ground, Dim+ (Purple) to Dim+ on the dimmer, and
Dim- (Pink) to Dim- on the dimmer.
Note: If not using the dimming feature, do not connect the
dimming wires. Terminate and cap the Dim+ and
Dim- wires separately.