Publicité
Les langues disponibles
Les langues disponibles
Precautions for use
To ensure safe use of your FORGE
ADOUR plancha, it is essential to comply
with the different rules for installation and
use below:
Remember to remove the protective
adhesive film from the stainless steel parts.
Between use, be sure to close the liquid gas
bottle valve.
This is a gas heated appliance intended for
outdoor use only; indoor rooms, garages,
cellars, canteens, caravans, boats are not
locations for its use. Open gardens, open
patios or breezaways can be considered as
outdoor locations.
Do not store or use flammable products or
vapours near the plancha.
If there is a smell of gas, close the liquid
gas bottle valve and never operate the
appliance.
If the appliance is placed on a support
(table, etc.), it must imperatively be fitted
with its 4 legs and the supporting table must
be made in a heat resistant material (not in
wood).
Your FORGE ADOUR plancha is not
connected to a combustion product
discharge system. It must be installed
and connected in accordance with the
installation rules in force.
Warning: some accessible parts may
be very hot. Keep young children away
and don't touch mettalic parts of
plancha until all surfaces have fully
cooled down (30 minutes after the
turninf off for the burners).
Do not move the appliance while in
operation. Check the ground or support is at
level without slope.
Do not use an adjustable pressure relief
valve.
Allow the plancha to cool before cleaning
the chassis and handling the grease tray.
Make sure that the hose is not in contact
with the hot parts of the appliance.
If your appliance is protected by a soft
cover, be sure to remove it completely
before using the plancha.
If your plancha is equipped with a lid, make
sure that this lid is in the "OPEN" position
while heating and in use.
For use without a FORGE ADOUR wheeled
unit or support: the gas bottle (13 kg) which
supplies the plancha must be placed 80 cm
away from the appliance.
If the plancha is to be used on a wheeled
unit or support, it is essential to use a bottle
weighing 6 kg max.
Warning: tightness is to be checked
outdoors, away from any source of ignition.
Make sure that the control switches are
in the closed position. After opening the
bottle and resetting the pressure relief
valve, check that there are no bubbles on
all fittings, on the pressure relief valve and
on the appliance, using soapy water. The
presence of bubbles indicates a leak.
Before any use check the plancha cooking
plate is clean and gas controls in order
to work; verify the burners holes and gas
nozzle zone is free from dirty, dust or
insects leavings. A clogged gas jet could
lead to fire and danger for users.
Close the gas bottle and tighten all the
fittings.
Repeat the tightness test. If the leak comes
from the appliance, do not use your plancha
and contact the manufacturer or the
retailer.
It is recommended to wear gloves when
handling particularly hot components.
17
Publicité
