Publicité
Les langues disponibles
Les langues disponibles
(other than those listed in this manual) should be
performed by authorized service centers or other
qualified service personnel, always using identical
replacement parts.
BATTERY REMOVAL AND DISPOSAL
This product uses lithium-ion rechargeable
and recyclable batteries. When the batteries
no longer hold a charge, they should be
removed from the product and recycled. They
must not be incinerated or compacted.
The batteries can be taken for disposal to
a BLACK+DECKER, Company-Owned or
Authorized Service Center. Some local retailers
are also participating in a national recycling
TM
program (see "RBRC
Call your local retailer for details. If you bring
the batteries to a BLACK+DECKER Company-
Owned or Authorized Service Center, the
Center will arrange to recycle old batteries.
Or, contact your local municipality for proper
disposal instructions in your
city/town.
TO REMOVE THE BATTERY PACK
FOR DISPOSAL:
1.) First, before attempting to disassemble
the product, turn it on and run it in either
direction until it stops to ensure a complete
discharge of the batteries.
2.) Remove the screws in the product housing
and lift the housing half from the tool.
3.) Disconnect the terminal clips from the
batteries and lift the batteries out.
4.) Place the battery in suitable packaging
to prevent a short circuit of the battery
terminals.
5.) Dispose of batteries as per
recommended guidelines.
ACCESSORIES
Recommended accessories for use with
your tool are available from your local dealer
or authorized service center. If you need
assistance regarding accessories, please call:
1-800-544-6986.
WARNING:
The use of any accessory
not recommended for use with this tool could
be hzardous.
THE RBRC™ SEAL
The RBRC™ (Rechargeable
Battery Recycling Corporation)
Seal on the lithium-ion battery (or
battery pack) indicates that the
costs to recycle the battery (or
battery pack) at the end of its useful life have
already been paid by BLACK+DECKER. In
some areas, it is illegal to place spent lithium-
ion batteries in the trash or municipal solid
waste stream and the RBRC program
provides an environmentally conscious
alternative. RBRC in cooperation with
BLACK+DECKER and other battery users, has
established programs in the United States and
Seal").
Canada to facilitate the collection of spent
lithium-ion batteries. Help protect our
environment and conserve natural resources by
returning the tool to an authorized
BLACK+DECKER service center for recycling.
You may also contact your local recycling
center for information on where to drop off the
spent battery, or call 1-800-8-BATTERY.
SERVICE INFORMATION
All BLACK+DECKER Service Centers are staffed
with trained personnel to provide customers
with efficient and reliable power tool service.
Whether you need technical advice, repair, or
genuine factory replacement parts, contact the
BLACK+DECKER location
nearest you. To find your local service
location, call: 1-800-544-6986 or visit
www.blackanddecker.com
This Class B digital apparatus complies
with Canadian ICES-003. This device
complies with part 15 of the FCC rules.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
NOTE: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy
and, if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
Changes or modifications to this unit not
expressly approved by the party responsible
for compliance could void the user's
authority to operate the equipment. This
Class B digital apparatus complies with
Canadian ICES-003.
8
Publicité
