Publicité
Les langues disponibles
Les langues disponibles
Controls
Temp Control
same level of comfort.
Press the + pad to raise the temperature.
Press the - pad to lower the temperature.
NOTE:
room temperature.
Fan, Mode and Operation Control
FAN—Sets the fan operation for HIGH or LOW.
MODE— COOL—For cooling
FAN—For fan-only operation
HEAT—For heating
OFF—
Sentinel features still function if active. See the
Freeze/Heat Sentinel section on page 8.
USE WALL THERMOSTAT—
the unit is controlled by a wall thermostat. See page 9 for
details.
Quick Heat Recovery
Activates each time the thermostat is switched from OFF or
COOL mode to HEAT mode. Electric heaters are energized
until the thermostat set point is reached. On heat pump
call for heat.
About Your Heat Pump (AZ65 only)
Heat pumps can save money by removing heat from the
outside air—even when the outside temperature is below
freezing—and releasing that heat indoors.
don't change the room thermostat by more than one degree
at one time. Raising the heat setting 2–3 degrees will cause
reach the new temperature setting quickly.
pumps and cost more to operate.
6
Control Lock Out
changing the operation mode of the unit.
While the unit is in the desired operating mode, press and
lock the control and the desired setting. Any key press after
locked to flash 5 times and then go dormant.
normal operation.
NOTE: The temperature display will flash if the control
panel is locked (see Control Lock Out section).
NOTE: When switching between modes, it may take
several minutes to completely change operation.
setting to prevent short cycling.
compressor cycles off.
When the outdoor temperature is lower than 25°F, heat is
provided by the electric heater instead of by the heat pump.
49-7774
Publicité
