CASO DESIGN 2871 Manuel D'instructions Original page 36

19.1 Security advices
► Repairs of electrical appliances must be carried out by qualified personnel who are
trained by the manufacturer.
► Repairs performed by untrained persons may result in considerable hazards for the user
and damage the machine.
19.2 Troubleshooting
Problem
The device does not start.
The device is blocked
The device stoped.
► If above mentioned steps don't solve the problem, please contact your customer
service.
► Clean the device before you send it to customer service.
20 Disposal of the Old Device
Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety. If these were put in the non-recyclable waste or
were handled incorrectly, they could be detrimental to human health and the
environment. Therefore, do not put your old device into the non-recyclable waste under
any circumstances.
Utilise the collection point, established in your town, to return and recycle old electric
►
and electronic devices. If necessary, contact your town hall, local refuse collection
service or your dealer for information.
Ensure that your old device is stored safely away from children until it is taken away.
►
Attention
Solution
• Please check whether the power plug is properly plugged.
• Please check whether the assembly is done according to
assembly methods.
• Turn the switch to REV to loosen the blockage. If this is not
enough please switch of the device, unplug the cord and
deasemble the device to remove the blockage.
• The device is overheated. Switch of the device, unplug the
cord. Deasemble the device and remove all ingredients
from the device. Let it cool down for 60 minutes.
• Contact customer service if overheating system is activated
too often.
Please note
Please note
36