Brizo T75661 Manuel Du Propriétaire page 6

75 Series Installation
4
Valve Trim Installation
A.
2
1
3
4
Temperature Control Handle Installation
Install temperature control handle (1) onto
cartridge stem (2) and secure using screw (3).
Snap on decorative cap (4).
5
Potential scald or thermal shock injury could result due to cross flow if outlet at
the shower is blocked or restricted (e.g., pause control on showerhead). Be sure
to point showerhead away from you when re-starting flow or install inlet check
valves on both supply lines to prevent possible injury.
82666 Rev. D
B.
1
3
4
Diverter Handle Installation
Insert diverter handle (1) onto trim sleeve stem (2).
Using a allen wrench, insert set screw (3) into
handle (1). Applying pressure, insert set screw
cover (4) until properly seated.
6
2