Subaru F551SSL100 Instructions D'installation page 2

INSTALLATION INSTRUCTIONS
If the center second row seat belt is installed, unlatch the seat
1
belt and retract it to the ceiling mount.
Open the cover to the cargo hook assembly. Remove the
3
bolt holding the assembly in using a 10mm socket and then
remove the complete cargo hook assembly. Repeat on
opposite side. Store both cargo hook assemblies in the
hardware bag and then place bag in glove box for future use.
Remove the plastic cover and install the upper left bracket on
5
the driver's side interlocking the lower left bracket and install
one of the larger internal diameter washer and an upper bolt
into the upper mounting location shown using a 10mm socket.
Torque upper bolt to 8Nm ± 0.56Nm (70.8 in-lbf ± 5.0 in-lbf).
Repeat on opposite side.
ISSUE
00
PART NUMBER: F551SSL100
DESCRIPTION: Forester Cargo Separator
Fold the second row of seats down to allow for easier cargo area
2
access during installation.
Install the lower left bracket on the driver's side using a spacer, one of
4
the smaller internal diameter washers, and a lower bolt using a 10mm
socket. Push the bracket downwards until the lower flange of the
bracket contacts the carpeting. Torque lower bolt to 8Nm ± 0.56Nm
(70.8 in-lbf ± 5.0 in-lbf). Repeat on opposite side.
Install the cargo separator mesh onto the studs of the brackets and
6
install all four of the smaller internal diameter washers and flange nut
and tighten to 8Nm ± 0.56Nm (70.8 in-lbf ± 5.0 in-lbf) Install four
plastic caps onto the exposed studs.
SUBARU OF AMERICA
4/2/2024 PAGE 2/2