Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
INSTALLATION INSTRUCTIONS
Mesh
A
Bolt
D
4X
Thread Cap
H
4X
NOTE: This cargo separator is not suitable for containment of a pet. The cargo separator is designed to prevent average
cargo larger than 10" x 10" stored in the cargo area from entering into the passenger compartment area. Items smaller
than 10" x 10" may be able to pass through the openings on the side of the cargo separator that are required to provide
clearance for the side curtain air bag.
VERSION
DATE
01
04/16/19
PART NUMBER: F551SAN400
DESCRIPTION: Outback Cargo Separator
Driver Side Bracket
B
1X
Spacer
E
4X
PAL Nut
I
4X
SUBARU OF AMERICA
C
1X
Large Flat Washer
F
8X
Zip-lock
J
Storage Bag
1X
This product has been designed to allow for proper function of
various vehicle safety components. Spacing near the side
windows on both sides of the cargo separator are included in the
design to allow for proper side curtain air bag clearances in the
event of air bag deployment. Additionally, installation of this
product will restrict the rear seats from fully reclining.
Passenger Side Bracket
1X
Flange Nut
G
4X
TOOLS REQUIRED
Trim removal tool
M10 Hex
Socket with
M10 Hex Socket with
Ratcheting
Torque Wrench
Wrench
PAGE
1/8
Publicité
Manuels Connexes pour Subaru F551SAN400
Sommaire des Matières pour Subaru F551SAN400
- Page 1 PART NUMBER: F551SAN400 INSTALLATION INSTRUCTIONS DESCRIPTION: Outback Cargo Separator Mesh Driver Side Bracket Passenger Side Bracket Bolt Spacer Large Flat Washer Flange Nut Thread Cap PAL Nut Zip-lock TOOLS REQUIRED Storage Bag Trim removal tool M10 Hex Socket with M10 Hex Socket with...
-
Page 2: Installation Instructions
Push evenly on 2 sides of the PAL Nut until it is engaged with the Spacer. Repeat steps 5 and 6 for the 3 remaining holes in the brackets. VERSION DATE PAGE SUBARU OF AMERICA 04/16/19... - Page 3 Tighten all four flange nuts (I) to T = 70.8±5 IN- the 2 studs on the right bracket. Hand tighten. LBF (8.0±0.56 N-M) using a 10mm socket with torque wrench. Torque in order shown. T = 70.8±5 IN-LBF (8.0±0.56 N-M) VERSION DATE PAGE SUBARU OF AMERICA 04/16/19...
- Page 4 Install the four cap plugs (H) onto the ends of the Pull the second row seat belt back down in front 4 studs sticking out towards the cargo area. of the cargo separator and engage it with the latch in the second row. VERSION DATE PAGE SUBARU OF AMERICA 04/16/19...
- Page 5 NUMÉRO DE PIÈCE : F551SAN400 INSTRUCTIONS D’INSTALLATION DESCRIPTION : Séparateur de fret dans l'Outback Treillis Support côté conducteur Support côté passager Boulons Entretoise Grande rondelle Écrou à embase plate Bouchon fileté Écrou-capuchon Le sac de OUTILS REQUIS rangement à fermeture en...
- Page 6 PAL jusqu'à ce qu'il soit engagé avec l'entretoise. Répétez les étapes 5 et 6 pour les 3 trous restants dans les supports. VERSION DATE PAGE SUBARU OF AMERICA 2019-04-16...
- Page 7 8 N.m ± 0,56 N.m(70,8 lb-po ± 5,0 lb-po) à Serrer à la main. l'aide d'une douille de 10 mm et une clé dynamométrique. Serrer dans l'ordre indiqué. C = 8 N.m ± 0,56 N.m (70,8 lb-po ± 5,0 lb-po) VERSION DATE PAGE SUBARU OF AMERICA 2019-04-16...
- Page 8 Installer les quatre capuchons (H) sur les Tirer la ceinture de sécurité de deuxième rangée extrémités des goujons dépassant dans l'espace vers le bas à l'avant du séparateur d'espace utilitaire. utilitaire et enclencher le verrou dans la deuxième rangée. VERSION DATE PAGE SUBARU OF AMERICA 2019-04-16...