Télécharger Imprimer la page

Rockford Fosgate POWER T3002 Installation Et Fonctionnement page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

PARA-PUNCH REMOTE BASS
Mounting and installation
1.
Find a location that gives easy access to the remote.
NOTE:You can mount this unit in a variety of ways. Remove the back housing by using a small flat
screwdriver in the slotted hole at the back.The housing can be installed with the mounting tab up
or down, or left off for in panel installation.
2.
Route the cable for the remote and connect to the amplifier.
Outside Panel Install
3.
Using the screws supplied, install the
mounting clip.
4.
Slip the remote onto the mounting
clip until it snaps into place.
5.
Connect the cable to the remote.
Panel Install
6.
Cut out a 2"x 7/8" hole in the panel,
with a maximum panel thickness of
3/8". Ensure there is enough room
within the panel area for connection.
7.
Route the cable through the hole and connect to
the remote.
8.
Press the remote into the panel cutout until it clicks
in place.
Operation
9.
Left Knob-Bass Boost Control:Turn clockwise to
boost amplifier bass frequencies.
CAUTION:Overexcursion and subsequent
damage may occur at high levels
of boost
10. Right Knob-Center Frequency Control:
Turn clockwise to select the center frequency
desired (35Hz-70Hz).
O
PERATION
Mounting Clip
+18
+14
+10
+6
+2
dB
0
-2
20
30 40 50 70 90
200
Hz
11

Publicité

loading

Ce manuel est également adapté pour:

Power t4004