Publicité
Les langues disponibles
Les langues disponibles
en Faults – what to do?
3
Faults – what to do?
Before you call customer service, use this table to check whether you can rectify the
d o ?
F a u l t s – w h a t t o
fault yourself.
Temperature differs greatly from the set value.
Displays do not illuminate.
The mains plug has not been inserted properly.
The fuse has tripped.
The power has failed.
Display indicates "E...".
Electronics have detected a fault.
A warning signal sounds and the alarm button is lit.
Appliance door is open.
Ventilation openings have been covered.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
--------
28
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the appliance"
on page 24
If the temperature is too warm, check temperature
again after a couple of hours.
If the temperature is too cold, check temperature
again on the following day.
Connect the mains plug.
Check the fuses.
Check whether the power is on.
Call the customer service.
~ "Customer service" on page 29
Press the alarm button. Alarm is switched off.
Close the appliance door.
Clear ventilation openings.
Start the appliance self-test.
~ "Customer service" on page 29
When the programme has ended, the appliance
switches over to normal operation.
Publicité
