Publicité
Les langues disponibles
Les langues disponibles
USER INSTRUCTIONS:
Starting of the machine:
1.
Remove the machine from its packing and make sure all packing parts have been taken off (including the
protection bags).
2.
Lay the machine on a flat and steady surface far away from hot places and from the water taps.
3.
Remove the water tank cover (19) placed on the top of the machine and take out the water tank paying
attention not to damage the water tubes inside the tank.
4.
Fill the tank with cold water.
5.
Replace the water tank back in the machine and check that the water tubes are not bent and that the filter is
well set on one of them; reposition the tank cover (19).
6.
Plug in the machine in the mains. Make sure that the wall socket has the right voltage.
7.
Place the filter holder (8) under the brewing group (5) and turn it from the left to the right. Leave it there so
that it can get warm and it gets ready for use.
8.
Turn the machine on by pushing the on /off switch (11). The indicator light (14) comes on to confirm the
power supply.
9.
Open the steam/hot water knob (4).
10.
Position the lever switch (13) on hot water mode (middle) and push up the switch (22).
11.
When water comes out of the steam nozzle (6), let down the switch (22) and close the steam/hot water knob
(4). Position the lever switch (13) on coffee mode (down).
12.
After completing all these operations, leave the machine on.
Preparing an espresso:
13.
Check that the water tank has been filled in with water by looking at the water level indicator (20).
14.
Press the on/off switch (11): the indicator light (14) will come on. Do this operation only if the machine is off.
If it's on pass to the following point. Make sure the lever switch (13) is on coffee mode (down).
15.
As soon as the indicator light (21) comes on, the machine is ready for use. PL41LEMAUS: the indicator light
(21) goes off.
16.
Fit the single cup filter (9) or the two-cup filter (10) into the filter holder (8) that has been warmed up by
leaving it attached to the brewing group as described in point 7.
17.
Fill the filter with ground coffee by means of the supplied measure spoon (16): 1 measuring spoonful (16) = 1
coffee cup - 2 measuring spoonful (16) = 2 coffee cups. Every time you fill the filter with a spoonful of coffee,
press the coffee with the coffee press/tamper (15) before proceeding to fill it with the next spoonful and make
sure that there are no coffee rests on the filter border.
18.
Insert the filter holder (8) in the brewing group ring (5), turn it from left to right with force, and then put the
cup on the removable water drainage tray (7).
19.
Push up the coffee/hot water lever switch (22). The manometer (17) will show the reached pressure, between
8 and 14 bar.
20.
Once you get the desired quantity of coffee, push down the switch (22) again.
21.
Remove the filter holder (8) and throw away the coffee grounds. Make sure that the filter holder is clean and
reposition it in the brewing group to warm up again.
Preparing an espresso with the use of coffee pods:
22.
Check that the water tank has been filled in with water by looking at the water level indicator (20).
23.
Press the on/off switch (11): the indicator light (14) will come on. Do this operation only if the machine is off.
If it's on pass to the following point. Make sure the lever switch (13) is on coffee mode (down).
24.
As soon as the indicator light (21) comes on, the machine is ready for use. PL41LEMAUS: the indicator light
(21) goes off.
25.
Fit the pod filter (18) into the filter holder (8) that has been warmed up by leaving it attached to the brewing
group as described in point 7.
26.
Open the single packed pod and pay attention not to damage the pod.
27.
Place the pod in its filter (18).
28.
Insert the filter holder (8) in the brewing group ring (5), turn it from left to right with force, and then put the
cup on the removable water drainage tray (7).
29.
Push up the lever switch (22). The manometer (17) will show the reached pressure, between 8 and 14 bar.
30.
Once you get the desired quantity of coffee, push down the switch (22) again.
31.
Remove the filter holder (8) and throw away the used pod.
Steam:
32.
Check that the water tank has been filled in with water by looking at the water level indicator (20).
33.
Press the on/off switch (11): the indicator light (14) will come on. Do this operation only if the machine is off.
If it's on pass to the following point.
34.
Position the lever switch (13) on steam mode (up/high position).
35.
As soon as the light (21) goes on, the machine is ready for use. PL41LEMAUS: the indicator light (21) goes off.
36.
Open the steam/hot water knob (4). First some water will flow out and then the steam.
37.
Put the cup with the desired infusion under the steam tube (6) and turn the knob (4) completely.
38.
When the drink has been suitably frothed, close the steam/hot water knob (4).
English
Pagina 11
Publicité
