CHIEF iC-PFM3 Serie Instructions D'installation page 15

Installation Instructions
3
interface
brackets
must be
hung on
opposite sides
of center tab
(views from left side)
2
kickstand
engaged
kickstand
against wall
1
center tab
5
locked
3
position
6
INSTALL DISPLAY TO WALL PLATE
WARNING:
Exceeding the weight capacity can
result in serious personal injury or damage to
equipment! It is the installer's responsibility to make
sure the combined weight of all components
attached does not exceed 125 lbs (56.7 kg) for the
iCMPFM3 and iCLPFM3 or 175 lbs (79.4 kg) for the
iCXPFM3. Use with products heavier than the
maximum weight indicated may result in collapse of
the mount and its accessories causing possible
injury.
WARNING:
Display may be very heavy! Ensure
display can be safely lifted and maneuvered as
required to install on wall plate. Failure to take
adequate precautions can result in serious personal
injury or damage to equipment!
WARNING:
Interface brackets must be hung on
opposite sides of the center tab on wall plate!
1. Make sure interface brackets are in the kickstand
position by pulling down on handles as far as
possible.
2. Hang display with brackets (B) on upper rail of wall
plate (A). Kickstand should be engaged with lower
portion of wall plate.
NOTE:
Any cable management or rear display
adjustments should be made when the display
is resting on the kickstand.
3. Unlock kickstand by pushing up on interface
brackets until kickstand rests against the wall.
4. Push up on the interface brackets further in order to
lock display into position against wall.
NOTE:
Straps can be either cut off or tucked behind
display after installation is complete so that
they will not be visable to the viewer.
5. (Optional) The straps can be moved to the lower
screw holes on interface brackets in order to
improve access to the straps on larger displays.
6. (Optional) Route padlock or cable lock (not
included) through bottom holes on interface
bracket to provide additional security.
4
iC-PFM3 Series
15