CHIEF iC-PFM3 Serie Instructions D'installation page 12

iC-PFM3 Series
1
(A)
1
3
(X) x 4
(W) x 4
4
1/2" (12.7mm)
12
(iCLPFM shown)
x 4
2
x 4
INSTALL WALL PLATE TO WALL - WOOD
STUDS
WARNING:
Failure to provide adequate structural
strength for this component can result in serious personal
injury or damage to equipment! It is the installer's
responsibility to make sure the structure to which this
component is attached can support five times the
combined weight of all equipment. Reinforce the
structure as required before installing the component.
The wall to which the mount is being attached may have
a maximum drywall thickness of 5/8" (1.6cm).
1. Unfold wall plate (A) to prepare it for mounting to wall.
2. Level wall plate (A) and mark locations of pilot holes.
NOTE:
For the iCXPFM3, any combination of holes can be
used for mounting to 24" studs as long as they are
24" apart. If mounting to 16" studs, only the inner
four holes may be used.
3. Drill 7/32" (5.5mm) diameter pilot holes into wood studs.
4. Using 1/2" (12.7mm) wrench, install screws (W) through
flat washers (X), wall plate (A) and into wood studs.
Installation Instructions