Installing Your Wine Cooler - CONTINENTAL EDISON YC-298B Guide D'utilisation

Before using your wine cooler
- Remove the outer and inner packaging.
- Check that you have all the following parts:
• The shelves
• 2 keys
• Stainless steel handle
• Instruction manual
- Before connecting the wine cooler to the power source, allow it to
stand in an upright position for approximately 2 hours. This will
reduce the possibility of cooling system malfunction due to handling
during transportation.
- Clean the interior surface with lukewarm water using a soft cloth.
- Install the handle on the left side of the door.

Installing your wine cooler

- This appliance is designed to be installed as a stand-alone or built-in.
- Place your wine cooler on a floor strong enough to support it when
fully loaded. To level your wine cooler, adjust the front leveling feet at
the bottom of the wine cooler.
- Place the wine cooler away from direct sunlight and sources of heat
(stove, heater, radiator, etc.). Direct sunlight can affect the acrylic
coating and heat sources can increase power consumption. Extremely
cold ambient temperatures can also cause the device to malfunction.
- Avoid placing the device in humid places.
- Plug the wine cooler into an exclusive, properly installed and
grounded wall outlet. Do not cut or remove the third (ground) prong
from the power cord under any circumstances. Any questions
regarding power and / or grounding should be directed to a certified
electrician or an authorized Products service center.
EN-20