Elem Garden Technic SBE2201 Traduction Des Instructions D'origine page 82

1， ， ， ， Cutting
1. Start machine and let the motor reach full speed.
2. Place a log on the working table
3. To make the cut, push the
- Exert only so much pressure that the motor speed does not fall off.
Push feed working table
-
4. Return working table
Note:
If the log was not completely separated, turn it over and repeat the cutting operation from the opposite
side (reversing cut).
1. Remove the cut off piece from the feed rock – make next cut...
2. If no further cutting is to be done immediately afterwards, turn machine OFF.
working table with both hands at the handle towards the saw blade:
until it hits the stop.
completely to the starting position.
- 82 -