Publicité
Les langues disponibles
Les langues disponibles
Cleaning and maintenance
For safety reason, each damaged (cracked) tool must be replaced before using.
Have all other work, repairs, conducted by a trained technician. If the supply cord is
damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons to avoid a hazard. Improperly performed work may cause
damage to the machine and result in injury.
In order to promise the safety, if the machine will not be used some long time,
please make inspection and replace of the damaged component before each use.
Prior to any maintenance and/or cleaning:
> Switch the machine off
> Let the machine cool down
> Pull out the plug.
> Empty the water tank and clean away any tile slurry from inside the tank and on
the table.
> Clean the tile saw with a clean dry cloth. From time to time depending on the
slurry accumulation clean the water pump making sure that filters are clean and
free from obstruction.
NOTICE
If the cooling water is very dirty, the efficiency if cooling water pump is reduced, and
this can result in damage or breakdown of the pump motor.
Repair
This product does not contain any parts that can be repaired by the consumer.
Contact a qualified specialist to have it checked and repaired.
Power
If the power cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons to avoid a safety hazard.
Transportation
1.Switch the product off and disconnect it from power supply before transporting it
anywhere.
2. Attach transportation guards, if applicable.
3. Protect the product from any heavy impact or strong vibrations which may occur
during transportation in vehicles.
4. Secure the product to prevent it from slipping or falling over.
Publicité
