Publicité
Les langues disponibles
Les langues disponibles
> If the tool is provided for the connection of dust extraction and collecting
equipment, ensure these are connected and properly used.
11. Do not abuse the cord
> Never yank the cord to disconnect it from the socket.
> Keep the cord away from heat, oil and sharp edges.
12. Secure work
> Where possible use clamps or a vice to hold the work.
> It is safer than using your hand.
13. Do not over reach
> Keep proper footing and balance always.
14. Maintain tools with care
> Keep cutting tools sharp and clean for better and safer performance.
> Follow instruction for lubricating and changing accessories.
> Inspect tool cords periodically and if damaged have them repaired by an
authorized service facility. Inspect extension cords periodically and replace if
damaged. Keep handles dry, clean and free from oil and grease.
15. Disconnect tools
> When not in use, before servicing and when changing accessories such as
blades, bits and cutters, disconnect tools from the power supply.
16. Remove adjusting keys and wrenches
> Form the habit of checking to see that keys and adjusting wrenches are removed
from the tool before turning it on.
17. Avoid unintentional starting
> Ensure switch is in "off" position when plugging in.
18. Use outdoor extension leads
> When the tool is used outdoors, use only extension cords intended for outdoor
use and so marked.
19. Stay alert
> Watch what you are doing, use common sense and do not operate the tool
when you are tired.
20. Check damaged parts
> Before further use of tool, it should be carefully checked to determine that it will
operate properly and perform its intended function.
> Check for alignment of moving parts, binding of moving parts, breakage of
parts, mounting and any other conditions that may affect its operation.
> A guard or other part that is damaged should be properly repaired or replaced by
an authorized service center unless otherwise indicated in this instruction
manual.
> Have defective switches replaced by an authorized service center.
> Do not use the tool if the switch does not turn it on and off.
21. Warning
Publicité
