Publicité
Les langues disponibles
Les langues disponibles
3. Bevel cutting
Follow the same procedure for a straight cut but:
> Loosen the Radial slide frame tilting knob (8) on both sides of the cutting
machine.
> Can't the frame with the guide track to the desired angle.
> Re-tighten the star handle bolts.
> Make bevel cut.
4. Compound cut
A compound cut is a combination of a bevel cut and a mitre cut, to perform this
action follow the instructions for bevel and mitre cuts to set up the machine in order
to perform a compound cut.
After using
When all cutting has been completed, switch off the machine and disconnect power
supply, cool the machine, and before storing the machine, it is advisable to
thoroughly clean the machine. Empty the water tank and clean away any tile slurry
from inside the tank and on the table.
Publicité
