Silence Alarm - Alecto SMARTCOA10 Mode D'emploi

TESTING:
When the CO detector is working under normal conditions, the sensor and
siren should be tested at least every week. Press the button. The detector
will then emit 4 beeps while the red LED flashes 4 times. If this occurs
everything is in order.
If the sensor detects an error, the yellow LED will flash while beep tones
are emitted.

SILENCE ALARM:

The alarm can sometimes activate because of environmental influences,
for example due to smoke with certain carbon monoxide concentrations or
other chemical gaseskand. If the CO value is below 150PPM, you can press
the button. The alarm sound will stop.
If the concentration is above 150PPM, it'll be impossible to stop the alarm.
The red LED continues flashing, yet the siren will stop for 5 minutes.
If the concentration increases above 150PPM, the alarm will continue.
LED INDICATION:
Red LED
Yellow LED
Green LED
BATTERY INFORMATION INDICATION:
1. Every 30 seconds, the battery is checked automatically.
2. Every 30 seconds, the green LED will flash for as long as the battery
power is higher than 3.5 Volts. This means the battery capacity is
sufficient. As soon as the battery power drops below 3.5 Volts, a beep
tone will be emitted when the green LED flashes briefly. At that time,
please replace the batteries as soon as possible.
Blinks quickly: Alarm, carbon monoxide present
Blinks 4 times: During test
Blinks: during warm-up
Blinks every 30 sec.: Battery almost empty
Twice every 30 sec.: Sensor problem
If it also beeps long, then short, this indicates the
sensor lifetime has expired.
Blinks: During warm-up
Blinks every 30 sec.: Normal functioning