Important - Alecto SMARTCOA10 Mode D'emploi

Important:

• This CO detector is not a replacement for smoke, fire or other detectors.
• The detector must be installed by a competent person.
• This detector cannot protect people with special medical conditions
• This detector might not prevent any chronic health effects of carbon
monoxide on the body.
• This CO detector is not a replacement for the correct installation, use and
periodic maintenance of combustion equipment, nor adequate ventilation of
spaces in which these devices are being used.
• We recommend you to weekly test the CO detector using the button on
the CO detector.
• This CO detector only sounds the alarm when carbon monoxide is present
at its sensor. Therefore, it's possible for carbon monoxide to be present
elsewhere and the alarm doesn't sound.
• When the alarm sounds, possible harmful carbon monoxide levels are
present! Carbon monoxide can be deadly!
Alarm
When the CO detector sounds the alarm, carbon monoxide (CO) might
be present
which can be fatal. Therefore, never ignore this alarm.
When there's an active alarm, the LED will illuminate and beep tones are
emitted continuously. When the carbon monoxide concentration drops
below 40PPM, the alarm will stop.
What to do when the alarm sounds:
1. Open doors and windows and immediately do outside into the fresh air.
Check whether everybody has left the building.
2. Call an official installer to inspect the correct functioning and state of
maintenance of the combustion source (gas or oil powered equipment) that
could be the cause for the CO alarm.
3. Only enter the building again after the cause has been resolved and the
building has been well ventilated.
The alarm sound can be switched off by pressing the button (<150PPM).
If the CO concentration drops, the alarm will eventually stop automatically.