BINDING THE TRANSMITTER AND RECEIVER
Your FTX transmitter will come ready bound to the vehicle directly from the factory. However should you need to
rebind the radio to the vehicle please follow these simple instructions:
PLUG IN THE BATTERY TO ESC AND TURN ON POWER
TURN ON THE TRANSMITTER
USE A PIN TO PUSH THE BIND BUTTON
Please Note: You must re-bind when binding to a different
transmitter. Also do not attempt to bind if there are other
compatible transmitters within 400ft when attempting to bind to
your transmitter as you may accidentally bind to these.
Charging/Installing the Battery.
Always store your
model with the battery
pack unplugged and
removed. Always
charge your battery
away from the vehicle.
The included 150mAh
USB charger will
take approx 4 hours
to charge a fully
discharged battery,
but always remove it from the charger
if it becomes warm to the touch. Always
disconnect the charger from the mains
supply and the battery pack when not in
use. Keep children away from charger and
battery during the charging process.
Notes on Battery use:
Always allow the battery cool after use, before recharging.
Always inspect the battery before charging.
Any bare wires, split heat shrink or leakage is a sure sign of abuse.
Never attempt to charge dead or damaged batteries.
Do not disassemble the battery or cut the connector wires.
If the battery connector gets hot enough to melt there is most likely a serious problem with your model, driveline, battery wires or
speed controller. Find and correct the problem before installing another charged battery pack.
NEVER charge the battery unattended
incase of overcharging,
you need to be able to monitor the
battery during charging
Charge away from flammable objects
and on a non-flammable surface incase
the battery becomes too hot.
FTXOBmini2.0XMan.indd 6
FTXOBmini2.0XMan.indd 6
The LED sequence for the USB charger is:
Light on = charging. Light off = Fully charged.
Connection Diagram for Electronics
6
07/01/2020 12:01
07/01/2020 12:01