GE PGP953 Instructions D'installation page 13

Installation Instructions
MAKING THE LP CONVERSION (cONT.)
[3] CHANGE COOKTOP BURNER
ORIFICES
Remove the grates, burner caps, and burner
heads.
Using a 7mm nut driver, remove the burner
orifices. These may be accessed through the
burner holes in the cooktop.
Inner oO
burner cap err
cap
Burner
Outer OR
base burner
gitye, Burner
zag head
se cap
Electrode B Burner
urner base
fod ccc ee}
Orifice spuds located Orifice spud located Electrode
through these Openings through this opening
Tri-Ring Burner
NOTE: On all burners, the
Retainer orifices have a spring-loaded
Ring retaining ring around the hex
head to hold the orifice in the
nut driver during installation
and removal. A slight amount
of force is required to push the
nut driver down over the ring.
Locate the LP/Propane orifices shipped inside
the literature package. They will have a digit
number and the letter "L" on the side.
(IMPORTANT: Save the orifices removed from
the appliance for future use.)
Each orifice will show a series of engraved
marks, (1, Il, IV or V), located on the top.
These marks denote the location of each orifice to the
cooktop burner.
©). C2. CG.
For PGP953 Models
©O.0.0.0
N o s e X2 alld x2 x1 Need x3, Tall
For PGP959 & CGP350 Models
See instructions
for center burner
13
[3] CHANGE COOKTOP BURNER
ORIFICES (CONT.)
CENTER BURNER
15,000 BTU/hr Extra Large Burner (PGP953 Models)
Burner
Cap
Set Screw
|
¢> Choke
|
Bummer
Head
Extended spud for center
extra large burner
Extended
Spud
Base
6
Orifice spud located
through this opening