Installation; Composition And Assembly Of The Loop; Installation Of The Loop In The Counter - Opus Technologies DCL20-K Manuel D'installation Et D'utilisation

DCL20-K | Manuel d'installation et d'utilisation | Installation and user manual |

3. Installation

Note:
The wire supplied in the DLC20-K
kit ensures the quick installation of a
magnetic loop system in a reception
desk, counter or cash desk.
In order to optimize the radiation of the magnetic
field and to guarantee a better result, the wire
should be placed close to the customer.
3.1 Composition and assembly of the
loop
The loop consists on the following 3 elements: a
loop cable, a loop adapter and a connecting
cable.
The loop is ready but it is possible to disas-
semble it to adapt it to the reception desk. See
below.
To disassemble the loop that will equip the
counter, first unscrew the support of the elec-
tronic card.
Connect the beginning and the end of the loop
cable to the circuit board (red connector).
Then plug the 50-70 cm connecting cable sup-
plied to the "amplifier" connector of the adap-
ter and to the "Loop" terminal block of the am-
plifier.
Your loop is now created and connected.
3.2 Installation of the loop in the coun-
ter
1. There are 2 possibilities to place a loop in a
counter as described below, however we
strongly advise you to use the first version:Place
the loop on the vertical and horizontal portion
of the counter as shown in figure 1. This type of
installation ensures better coverage in front of
the counter.
20
Loop
amplifier
Figure 1.