Publicité
Les langues disponibles
Les langues disponibles
PREPARE THE LOCATION(100CFM Ducted version)
Install Vent System
1.
Install vent through the vent opening in upper cabinet
INSTALL RANGE HOOD (Ducted
.
version)
Detach the 3¼" x 10" (8.3 x 25.4 cm) rectangular
•
damper from the package.
A. 3¼" x 10" (8.3 x 25.4 cm) rectangular vent damper
•
For roof installations, remove the top rectangular
For wall installations, remove the
vent knockout A.
rear rectangular vent knockout B.
B
A. Top rectangular knockout
B. Rear rectangular knockout
Internal recycle air outlet
3.
Use D air outlet,retention A and B materials
•
D
A
when use A or B air
outlet, need Insert c baffle
C
C. Long baffle
Vent Damper Installation
Install 3¼" x 10" (8.3 x 25.4 cm) vent damper.
Attach to range hood using the indicated screws
provided in hardware kit.
vent
B
If a vent damper is installed with a wall cap with
•
damper, check that they do not interfere with each
other. Remove the vent damper flap if they interfere.
Power Supply Cable Installation
1.
For direct wire installations, run the home power
supply cable according to the National Electric Code
or CSA standards and local codes and ordinances.
NOTE
Do not reconnect power until the installation
is complete.
Before starting the installation, remove the
vent grill and grease filters.
Remove the screws from the terminal box cover.
.
Remove terminal box cover and set aside.
A. Terminal box cover
B. Screw
11
Install the 3¼" x 10" (8.3 x
B
25.4 cm) rectangular vent
transition
A. 3¼" x 10" (8.3 x 25.4 cm)
C
A
B
A
Publicité
