Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Inspection
Please check the contents of the package after receiving it. First, check that all items are included. Then check
the water pump for any concealed damage. If you have any problems, please contact the store where you
purchased it.
Electrical Requirements
FOR YOUR SAFETY
This Pump must be installed by a qualified pool professional or licensed or certified
electrician and must conform to National Electrical Code all national, state, and
local codes. Before installing this product, read and follow all warning notices and
instructions that accompany this product. Failure to follow warning notices and
instructions can result in property damage, personal injury, or death.
Turn the power supply OFF before installing or servicing pump.
Before installing the pump, open the carton and check the pump for concealed damage, for example,
dents, a broken base, cracks etc. If any damage is found, please contact the original purchasing shop.
Plumbing Installation
•
Protect the pump against direct sunlight and excessive moisture (sun and rain etc.).
•
Place pump on a solid surface as close to the pool as possible. For trouble-free self-priming, consult
local regulations for minimum distances between pool and pump.
•
Leave enough space for maintenance and service.
•
To reduce friction loss, use direct and short piping to the suction.
•
Ensure the surface drainage is adequate to prevent flooding.
•
The pump suction inlet height should be as close to the water source as possible, it's not allowed more
than five feet.
•
Avoid using a suction pipe smaller than pump connection. Suction pipe should be same or larger than
discharge pipe.
•
Prevent the motor from overheating. Ensure that the pump is properly ventilated.
7
EN
Publicité
