Publicité
Les langues disponibles
Les langues disponibles
EN
Risk of Electric Shock. Connect only to a branch circuit protected by a ground-fault
circuit-interrupter (GFCI). Contact a qualified electrician if you cannot verify that the
circuit is protected by a GFCI.
Always disconnect power to the pool pump at the circuit breaker before servicing the
pump. Incorrectly installed equipment may fail, causing severe injury or property
damage. The pump is capable of high flow rates. Be careful when installing and
programming to limit pump's performance potential with questionable or old equipment.
To reduce the risk of property injury or damage, do not attempt to change the backwash
(slide, full flow or multiport) valve position with the pump running.
To reduce the risk of injury, do not permit children to use this product.
To minimize the risk of severe injury or death, the filter and/or pump should not be
subjected to the piping system pressurization test.
Do not store pool chemicals near your equipment. Chemical fumes and spills can weaken
pool/spa equipment. Corrosion can cause filters and other equipment to fail, resulting in
severe injury or property damage.
Failure to keep suction outlet components clear of debris, such as leaves, dirt, hair, and
other material can result in an increased potential for suction entrapment. Do not start
pump dry! Running the pump dry for any length of time will cause severe damage and
will void the warranty.
This pump is for use with permanently installed pools and may also be used with hot
tubs and spas, if so marked. Do not use with storable pools. A permanently installed pool
is constructed in or on the ground or in a building such that it cannot be readily
disassembled for storage.
Do not install within an outer enclosure or beneath the skirt of a hot tub. The pump
requires adequate ventilation to maintain air temperature at less than the maximum
ambient temperature rating listed on the motor rating plate.
3
Publicité
