DAB EUROINOX 30/50 Instructions Pour L'installation Et La Maintenance page 29

8. Trouble shooting
fault
Pump alarm LED.
Water leak from the
trap discharge pipe.
The pump fails to start.
The pump starts but
fails to restart.
The pump works
intermittently.
The pump fails to stop.
The pump jams.
9. Declaration of conformity
For the Active Switch product, we hereby declare that the device described in this instruction manual and marketed
by us conforms with the relevant EU health and safety regulations.
The product is accompanied by a detailed and up-to-date declaration of conformity.
If the product is modified in any way without our consent, this declaration will lose its validity.
cause
Lack of water.
Motor or impeller blocked.
Motor overheating.
Hydraulic regulator blocked
by limescale.
The hydraulic regulator float
touches the side of the tank.
Mains pressure too high.
The water column is too
high.
System loss less than the
minimum flow.
System loss greater than the
minimum flow.
Suction difficulties / Actual
pump prevalence insufficient.
ENGLISH
solution
When the water returns, disconnect and then reconnect the
power supply plug, the reset occurs automatically at preset time
intervals.
Make sure the mains flow rate is over 10 l/min.
Make sure that the impeller is free of dirt.
Make sure that there are no obstacles blocking the air intake
and outlet.
Fit a filter against limescale.
Slacken the hydraulic regulator locking ring, and move the float
so that it no longer touches the side of the tank, then tighten the
locking ring again.
Install a pressure regulator on the inlet to the mains tank.
Check the electrical wiring
Contact the assistance centre.
Check the integrity of the system.
Check the integrity of the system.
Check for obstructions.
27