Publicité
Les langues disponibles
Les langues disponibles
17 Take care to avoid entanglement of loose
moving parts of the tool which should be kept dry and clean for best possible
18 When carrying the tool from place to place keep hands away from the trigger/lever to avoid
inadvertent start up.
19 Excessive contact with hydraulic fluid oil should be avoided
of rashes, care should be taken to wash
3. PREPARATION
AIR SUPPLY
All tools are operated with compressed air at an optimum pressure of 5.5
the use of pressure regulators and automatic oiling/filtering systems on the main air
These should be fitted within 3 metres of the tool (see diagram below) to ensure
maximum tool life and minimum tool
The air supply pipes used must have a suitable pressure resistance. Air hoses should be oil
resistant, have an abrasion resistant exterior and should be armoured where operating conditions
may result in hoses being damaged. All air hoses MUST have a minimum bore diameter of 6.4
1 /
millimetres or
4
inch.
Read servicing daily details.
OPERATING PROCEDURE
clothes, ties,
long
hair,
.
thoroughly.
maintenance.
www.degometal.com
cleaning rags etc. in the
grip.
To minimize the possibility
bar.
We recommend
supply.
19
Publicité
