Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
Power ON and OFF
1.
Gently pull the trigger to turn the thermometer on. The LCD
display and the backlight will turn on.
2.
The thermometer will automatically shut off after 15 seconds
of inactivity.
Manual Measurement
1.
Pull and hold the trigger after aiming at the target. The
will flash, indicating that the target temperature is being measured.
2.
When the trigger is released, the
icon will appear indicating that measurement has stopped
and the last measured temperature will remain on-screen until
another measurement is taken or the unit turns off.
Continuous Temperature Measurement (Trigger Lock)
The instrument allows for a continuous temperature measurement time to
be set from 1 minute to 5 hours. Refer to Trigger Lock Setup for details.
Note: This function is applicable for processes that require regular moni-
toring of temperature.
1.
Once the trigger lock function is enabled, the
the display and the SCAN icon will flash when the trigger is pressed.
2.
Pull the trigger again to stop measuring and both the
icons will disappear and the HOLD icon will appear. The thermometer
will now hold the last measured value until the unit turns off after 15
seconds of inactivity or until testing is resumed.
3.
When the continuous temperature measurement time is reached, the
thermometer will automatically power off and save the last measured
value. You can view the last measured value by pulling the trigger.
Note: The last measured value is cleared when a new test scan is started.
www.REEDINSTRUMENTS.com
icon will disappear and the
icon will appear on
and SCAN
icon
continued...
9
Publicité
