Pur Line HYDRO 20 Manuel D'utilisation page 9

CONTROL PANEL
REMOTE CONTROL: has the same functions that the control panel.
CLEANING AND MAINTENANCE
In case when the water is hard which means water contains too much calcium and magnesium, they can cause
"white powder" problem and give heavy scum on the surface of water basin, transducer and inner surface of
the water tank. Scum on the surface of transducer will make the unit work improperly.
WE RECOMMEND:
• Use filtered water or distilled water.
• Clean the transducer, water tank and basin unit every week.
• Change the water in water tank more often to keep it fresh.
• Clean the whole unit, and make sure to keep all parts of the unit dry completely when the unit is not in use.
HOW TO CLEAN THE TRANSDUCER:
for 2-5 minutes. 2. Brush out the scum on the surface. 3. Rinse the transducer with clean water.
HOW TO CLEAN THE BASIN UNIT:
scum in it. 2. If the scum is covered on the security switch, drop the vinegar on the scum and clean it out with
the brush. 3. Rinse the water basin with clean water.
CLEAN THE TANK FILTER:
Shake about 10 times and rinse with water. 4. Leave to dry.
1. Light
Turn on the humidifier, the machine will enter the blue LED Light automatically.
Press "Light"button to off the blue LED light.
2. Timer
Press "Timer"button, the screen will show the timer digit (adjust starting from
1 hour). Each press will add 1 hour, able to set until 14 hours, then enter timer
mode. When the operating time reaches the time set, the machine will stop
operating (Note: the timer digit is by countdown).
3. Humidity
TPress"humidity" button to adjust humidity level. The starting humidity is 55%.
Press one time to add 5%. (The humidity level setting is from 40%,45%,50%
-- 55% 60% 65% 70% 75%RH). "--"is dismiss humidity mode.After set to the
preferred humidity level, the digit will blink 3 seconds and enter the humidity
mode. The humidity digit shown is current humidity level. When the humidity
reaches the set level, the mist function will stop working. When the humidity is
lower 5%RH than the setting, the misting function will start working.
4. Sleep
Press "Sleep"button, the screen digit and bule LED lights in water tank will off
after 3 seconds, but other functions are operating as normal. Press any button
to dismiss sleep mode.
5. ON/OFF
Press "ON/OFF" button, the machine will enter default mode; the mist will be
at highest level. Blue LED light on; the screen showing current humidity level;
other function at standby mode.
6. Mist
The default mode as highest level mist 3, press one time to set
middle mist level, press second time for lowest level.
1. Put 5-10 drops of vinegar on the surface of the transducer, wait
1. Clean the water basin with soft cloth and the vinegar if there is
1. Remove the filter from the tank. Clean with a little vinegar and clean water. 3.
EN
7