Publicité
Les langues disponibles
Les langues disponibles
3. Use the additional suction cups to neatly guide the tubing along the
side panels to the inlet location of your terrarium.
4. Connect the tubing from the nozzles to the Y-connector by pressing
the tubing firmly into one of the side-by-side holes as far as
possible. Connect both nozzles.
5. Connect the tubing to the remaining hole of the Y-connector by
pressing it firmly inside as far as possible.
6. Place the Monsoon MULTI unit on a hard, stable, level surface.
7. Connect the tubing coming from the Y-connector to the top of the
unit by pressing the tubing firmly into the opening as far
as possible.
8. Make sure that the filter is properly connected to the spigot on the
underside of the control unit and placed inside the reservoir.
9. Ensure that the top of the Monsoon MULTI unit fits tightly on top
of the reservoir.
10. Open the small lid on top of the unit, and fill the reservoir with
de-mineralized/distilled water up to a maximum of 2,5 cm (1")
from the top rim of the transparent reservoir. (Using regular tap
water will cause clogging of the nozzles by mineral deposits!)
11. Close the lid and connect the power supply jack to the back of
the unit.
12. Make sure the unit is in its final operating location, standing level
on a hard surface.
13. Plug the power adaptor into the wall socket, your Exo Terra
Monsoon MULTI High-pressure Misting system is now ready to
use. In order to remove the tubing from either the Y-connector
or the unit, press and hold the blue ring down, while pulling out
12
the tubing. Please note that nozzles can be mounted in multiple
terrariums.
OPERATING MODES
Use one of the three operating modes mentioned below to create the
appropriate rain cycle for your animals. You can switch between the
operating modes by pressing one of the three buttons in the center of
the control panel (fig. F):
1. O: The Exo Terra
visible in this mode.
2. ON: The Exo Terra
light is illuminated and the unit will operate CONTINUOUSLY. The
blue LED lights that indicate the cycle settings (duration and cycle)
are illuminated and will show which cycle parameters will be used
when the mode is switched to "CYCLE" mode (see below).
PLEASE NOTE THAT IN THIS MODE THE MONSOON WILL NOT
SPRAY ACCORDING TO THESE CYCLE SETTINGS, IT WILL SPRAY
CONTINUOUSLY REGARDLESS OF THE CYCLE SETTINGS
3. CYCLE: The Exo Terra
"CYCLE" light is illuminated and the unit will operate according
to the cycle and duration settings. Also the blue LED lights that
indicate the cycle settings (duration and cycle) are illuminated and
show which cycle parameters are currently used. You can alter the
"cycle" and "duration" settings by simply pressing the buttons on
the dials on the left and right side of the control panel.
•
The left dial is to set the "cycle" (in hours) of the unit. Press the
button on the dial until the corresponding LED of your preferred
cycle is illuminated. For example, when the LED "4" is illuminated
Monsoon is switched off – No blue LED light is
®
Monsoon is switched on – the blue LED "ON"
®
Monsoon is in cycle mode – the blue LED
®
®
Publicité
