Husky 8200415A Manuel D'instructions page 8

Maintenance
FILTER REPLACEMENT – REPLACE WITH MULTI-FIT CARTRIDGE FILTER SKU#332340
WARNING: To reduce the risk of injury from accidental starting, unplug the power cord before changing or cleaning the lter. Your
lter should be cleaned often to maintain peak vacuum performance.
WARNING: Do not remove the lter cage and oat. The oat prevents water from entering the impeller and damaging the motor.
The cage prevents ngers from touching the moving impeller.
IMPORTANT: To avoid damage to the blower wheel and motor, always reinstall the reusable dry lter before using the vacuum for
dry pickups and always reinstall the foam lter before using the vacuum for wet pickups.
IMPORTANT: After cleaning, check the lter for tears or small holes. Do not use a lter with holes or tears in it. Even a small hole
can cause dust to come out of your vacuum. Replace it immediately.
NOTE: Before installing the lter on the vacuum, clean the area of the lid so that the clamp ring will seal the bag against the lid and
stop small particles from bypassing the lter bag. If the lter is clean and not damaged, replace it on the lter cage. If it cannot be
reused, place a new lter over the lter cage.
NOTE: Clean the lter in an open area.
STORAGE
□
Before storing your vacuum, the dust tank should be emptied and cleaned.
□
The cord should be wrapped and hung on the unit and the accessories should be kept in the accessory holder
so they can be readily available.
□
The vacuum should be stored indoors.
8