Husky 8200415A Manuel D'instructions page 7

Operation
1
Vacuuming dry
The reusable lter (M) can be used for dry pickup.
□
The lter must always be in correct position to reduce
the risk of leaks and possible damage to the vacuum.
Make sure that the lter is completely covering
the lter cage and that the clamp ring is as close to
the lid as possible. Make sure there are no gaps between
the lter and the lid. It is very important to assemble
the lter to the cage without allowing any possible leaks
or tears. Any leaks will allow the picked up debris to be
blown out of the blower port and back into the surrounding
environment.
□
When using the vacuum to pick up ne dust, it will be
necessary to empty the dust tank and clean or replace
the lter at more frequent intervals to maintain peak
vacuum performance.
□
The foam lter and reusable dry lter with ring must be
installed for dry pick up.
M
3
Blower
This vacuum features a blower port. Follow the steps below to
use the vacuum as a blower.
□
Locate the blower port (F) on the vacuum.
□
Insert one end of the 5 ft. x 1-1/4 in. hose (J) into
the blower port (F).
□
Turn the vacuum on/off switch (B) to "ON".
Clamp ring
B
7
2
Vacuuming wet
□
Remove the reusable filter (M) and replace it with the foam
filter (N) when you do wet pickups.
This wet/dry vacuum is equipped with a float mechanism
□
which will rise automatically to cut off the airflow when
the liquid in the tank reaches a predetermined level.
When this happens, turn off the vacuum, unplug the power
cord, and empty the dust tank. You will know that the float
has shut the airflow off because the suction ceases and
the motor noise becomes higher in pitch due to increased
motor speed. The liquid capacity may vary with the rate
of pickup.
IMPORTANT: To reduce the risk of damage to the vacuum,
do not run the motor with the float in raised position. Wet pick
up accessories should be washed periodically.
N
Float in raised position
Please contact 1-888-HD-HUSKY for further assistance.
J
F
HUSKYTOOLS.COM