Spypoint CELL-LINK Guide De Démarrage Rapide page 8

INSTALLING AND CONNECTING THE CELL-LINK
To connect the SPYPOINT CELL-LINK to your trail camera from any brand, follow
these steps (or view our video in the Help section):
1.
Open your camera door.
2.
Take the CELL-LINK memory card
adapter cable and insert the
end with the SD card into your
camera's SD card slot.
3.
Keeping the SD memory card
adapter cable held tightly against
the case, direct the adapter cable
so that it exits from the bottom of
the camera case. The cable should
hang loosely below the camera.
(Avoid bringing the cable over
any critical components).
4.
Shut the camera door and lock
the latch.
5.
Flip the SD cable upward, sliding it up behind the camera, so that the CELL-LINK
connector sticks out from behind the top of your camera.
6.
Mount your camera to the tree. (The CELL-LINK SD adapter cable should now be
found between the tree and camera)
7.
Mount the CELL-LINK cellular module as close to your camera as possible.*
8.
Connect the SD card cable connector to the CELL-LINK.
You can now access CELL-LINK photos, configurations, and statuses either via the
SPYPOINT app or your account on the SPYPOINT website.
It is strongly recommended to mount your CELL-LINK cellular
module directly above your camera leaving as little space as
possible between the two. Doing so will reduce the risk of having
NOTE:
animals cause damage to the cable.
If your cable memory card adapter gets damaged replacement
cables can be ordered separately.
8