Cabela's Gundog GS-8100 Manuel D'utilisation page 14

TO CHANGE THE ID CODE:
1. With the Toggle Switch in the Left position, follow the instructions on the previous page for changing
modes. At Step 4, use the up/down Side Buttons to select Mode 7 (ID Code).
2. Press and release the Left Button on the Remote Transmitter to set the selection. The unit will display the
current user ID on the display or "--" if the ID hasn't been currently set.
3. Use the up/down Side Buttons to select the desired ID. There are 10 programmable ID Codes available.
4. Press and release the Left Button on the Remote Transmitter to set the selection (LCD will flash three
times). Unit will revert back to original display and the current mode will still be active after ID selection.
STEP :: 06
MATCH THE COLLAR RECEIVER AND REMOTE TRANSMITTER
To match the Collar Receiver to work with a new Remote Transmitter or to match a new Collar Receiver to
work with your existing Remote Transmitter:
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off after 4-5
seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin flashing as
normal. If this occurs, start over from A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Left Button on the Remote Transmitter until the Receiver Indicator Light flashes
5 times. Once the Receiver Indicator Light has flashed 5 times, the Collar Receiver has been matched and
will begin flashing as normal. If the Receiver Indicator Light does not flash 5 times, start over from A.
STEP :: 07
PROGRAM THE SYSTEM FOR TWO-DOG OPERATION
The GS-8100 Collar Receiver can be set to respond to the Toggle Switch in the Left or Right position. A
Cabela's extra Collar Receiver (GS-009) must be purchased to train a second dog in two-dog mode.
1. Program the Remote Transmitter to any Mode 1 to 6 (see STEP 5).
2. Move the Toggle Switch to the Left position to program the first
Collar Receiver.
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver Indicator Light
will come on, then turn off in 4-5 seconds. If the On/Off Button
is released too early, the Receiver Indicator Light will begin its
normal flashing. If this occurs, start over and repeat from A.
C. After the Receiver Indicator Light has turned off, release the
On/Off Button.
D. Press and hold the Left Button on the Remote Transmitter until
the Receiver Indicator Light flashes 5 times.
3. Program the second Collar Receiver the same way using A through D
above, but with the Toggle Switch in the Right position.
14
LEFT FOR DOG 1 RIGHT FOR DOG 2
SET TOGGLE