Tiger PIF-A Serie Manuel D'instructions page 21

Symptom
Water does not dispense
using electric dispense key.
Display panels are fogged
up.
Display Messages
Symptom
The unit is equipped with Dry-Boil Protection.
Boil lamp and Keep Warm lamp flash alternately
and signs (as shown) appear on the display.
Flashing Flashing
Boiling Lamp and Keep Warm
Lamp flash alternately will appear
on the display as shown on right.
Check
Was hot water dispensed while the unit was
tilted?
Is the plug connected?
Is it set to lock automatically?
Is it immediately after the water has boiled?
Are the mesh filter or the inside pump dirty?
Was the unit placed in an area prone to
become wet or an area where the bottom can
get wet?
Has the unit been placed upside down?
When refilling with water, was water
splashed onto the operation panel?
Is there no water or very little
water in the container?
Has the unit been left for a
prolonged period after all of the
hot water was dispensed, or has
lid been left open while refilling
with water?
Flashing Flashing
When refilling, is water being
poured with excessive force?
Flashing Flashing
Action
Place the unit completely upright.
Connect the plug.
Press the Unlock key once to dispense hot
water.
Open the lid once while watching out for
steam.
Clean the unit with Citric Acid.
Discard water, unplug, and leave until the
panels are clear.
If you still have cloud in the water scale,
please contact customer service.
Check
Unplug, and refill to above the
refill level of the water volume
indicator. Leave as is for a while,
then plug in.
Unplug, leave for a while, then
plug in.
When refilling or cleaning the
heater, water may get inside
the unit and cause problems.
-
Request repair work from the
Tiger product retailer where the
appliance was purchased.
Reference
page
-
10
11
18
-
Reference
Action
page
10
-
20 20