Tiger PIF-A Serie Manuel D'instructions page 14

4
Dispensing Hot Water
1
Press the
2
Press the
Place a container under the spout, and press the
key.
Dispense
Hot water continues to dispense while pressing the
key.
Dispense
※ After checking that hot water has stopped dispensing, remove the
container from the spout
※ If the unit is unplugged, hot water cannot be dispensed.
※ When water is boiled, air pressure increases in the container so
that the water dispenser may not produce a smooth water flow
immediately after it is boiled. Release the air pressure by opening
the lid and then dispense the water. Be cautious of steam.
※ Mineral deposits can build on the wall of the inner container, mesh
filter or pump unit, causing water to not dispense.
※ If the
key is not pressed for approx. 10 seconds after
Dispense
dispensing hot water, the unlock lamp will be turned off and the
unit will lock automatically.
Dispense
key
• Do not dispense when water level is
Caution
at "Refill water mark". Hot water may
splash when you dispense.
• Pay close attention when dispensing
hot water so as to not spin the entire
unit around.
13 13
key once.
Unlock
Light
illuminates
key.
Dispense
3
Press the
Unlock
The key will be locked, and hot water cannot
Dispense
be dispensed even if the key is pressed.
■Refill water when level becomes low.
Be sure to refill water before it reaches [Refill water mark],
and close the lid securely. (Caution for hot steam when
refilling water. See p. 10)
• Do not leave the unit without any water
Caution
inside, this is to avoid malfunction due
to boiling without water.
• When using VE Mode (when the plug
is connected), the water is not boiled
even when dispensing hot water.
key once.
Light
turns o