Tiger PIF-A Serie Manuel D'instructions page 15

5
How to use Energy Saving Mode
Energy Saving Mode applies to Boiling and Keep Warm
cycles.
• Energy Saving Mode Boiling: heater will shut off when
temperature reaches 208°F and reduce boiling steam.
(Depending on the room and water temperature, the
steam cut function may not work.)
• Energy Saving Mode cycle applies after 2 hours not in
use. It reduces approximately 9°F from regular setting
temperature e.g.: If you select 208°F, Energy Saving
Mode is 203°F.
1
Select [Energy Saving Mode]
Energy Saving
Press and hold
Light
illuminates
■Disabling steam cut function for
Energy Saving Mode cycle.
Boiling cycle with dechlorinate.(See p. 10)
2
Select [Keep Warm]
(See p. 11)
3
Once water reaches boil-
ing point, it automatically
switches to Keep Warm
mode.
■When boiling cycle is done...
Light
turns o
key for a second.
Display
Flashing
Light
illuminates
Light
illuminates
■Water reaches setting temperature...
■If the unit is not in use for 2 hours, it
will automatically switch to Energy
Saving Mode.
( 9°F lower than regular setting temperature)
※ The heater is off during VE Mode cycle so water temperature will
decrease accordingly.
How to bring back to setting
temperature.
Press Temp.Set or Unlock
setting temperature about a minute.
How to cancel Energy Saving
Mode
Press Energy Saving key for a second. (It automatically
reheats when the temperature is low.)
Keep your face or other body parts away
Caution
from the steam vent which may be hot
during Energy Saving Mode boiling cycle.
Display
key once. Bring back to
14 14