Télécharger Imprimer la page

Generac Portable Products 1656-1 Manuel De L'utilisateur page 9

Publicité

Les langues disponibles

Les langues disponibles

OPERATmNG
THE
G E N E RATO R
See"Don't
Overload
Generator".
Start generator
and let engine stabilize before connecting
electrical
loads.
Connect
electrical
loads in OFF position, then turn ON for
operation.
"Furn electrical
loads OFF and disconnect
from generator
before stopping generator:
iMPORTANT:
AHways unpHug the battery float charger
before starting the generator.
Stardng
the
Engine
Disconnect
all electrical
loads from
the generator.
Follow
these
start
instruction
steps in numerical
order:
I.
Turn fuel valve to"On"
position (Figure 5).
2.
Make sure Idle Control switch is in "Off' position
(Figure 6).
IDLE
3_
Start
engine
according
to instructions
given in engine
owner's
manual.
WARNING
When
starting engine, pull cord sJow.ly until resistance is feJt
and then pull rapidly to avoid kickback.
NEVER start or stop engine with electrical
devices plugged in
and turned
on.
NOTE:
If engine
still fails to start
after
3 pulls, check
for
proper
oil level
in crankcase.This
unit is equipped
with
a
Low Oil
Shutdown
System.
See engine
manual.
WANNING
DO NOT touch hot surfaces.
Allow equipment
to cool before touching.
The generator
must be at least 5 feet from structures
having
combustible
walls and/or other combustible
materials.
Keep at least 3 feet of clearance on all sides of generator
for
adequate cooJing, maintenance
and servicing.
In the State of California
a spark attester
is required
by law
(Section 4442 of the California
Public Resources Code). Other
states may have similar laws. Federal Iaw.s apply on federal
lands. If you equip the muffler
with a spark arresten it must be
maintained
in effective working
order.
Connectin_
Electrical
Loads
o Let engine
stabilize
and
warm
up for a few
minutes
after
starting.
o Plug in and
turn
on the
desired
120 and/or
240VoltAC,
single
phase,
60 Hz electrical
loads.
o DO
NOT
connect
240Volt
loads
to the
120Volt
receptacles.
o DO
NOT
connect
3-phase
loads
to the
generator.
o DO
NOT
connect
S0 Hz loads
to the generator.
* DO
NOT
OVERLOADTNE
GENERATOR.
See
"Dofft
Overload
Generator".

Publicité

loading

Produits Connexes pour Generac Portable Products 1656-1