WARNING
When
starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
NEVER start or stop engine with electrical
devices plugged in
and mr'ned on.
WARNING
WHEN
ADJUSTING
OR MAKING
REPAiRSTOYOUR
GENERATOR
Disconnect
the spark plug wh'e from the spark plug and place
the wire where it cannot contact
spark plug.
WHENTESTING
FOR ENGINE
SPARK
Use approved spark plug tester
DO NOT check for spark with spark plug removed.
WARNING
DO NOT touch hot surfaces.
Allow equipment
to cool before touching.
The generator
must be at least S feet from structures
having
combustible
wails and/or other combustible
materials.
Keep at least 3 feet of clearance on all sides of generator
for
adequate cooling, maintenance
and servicing.
In the State of California
a spark arrester
is required
by law
(Section 4442 of the California
PuNic Resources Code). Other
states may have similar laws. Federal laws apply on federal
lands. If you equip the muffler
with a spark arresten it must be
maintained
in effective working
order:
w
l
CAUTION
DO NOT
tamper
with governed
speed. Generator
supplies
correct
rated frequency
and voltage
when
running
at governed
speed.
DO NOT
modify generator
in any WaT:
See "Don't
Overload
Generator".
Start generator
and let engine
stabilize
before
connecting
electrical
loads.
Connect
electrical
loads in OFF position,
then turn ON for
operatiom
Turn electricaI
loads OFF and disconnect
from generator
before
stopping
generator.
Use generator
only for intended
uses.
If you have questions
about
intended
use, ask dealer
or call
1-800-270-1408.
Operate
generator
only on level surfaces.
DO NOT
expose
generator
to excessive
moisture,
dust, dirt,
or" corrosive
vapors.
DO NOT
insert
any obiects
through
cooling
slots.
If connected
devices
overheat,
turn them
off and disconnect
them
from generator:
Shut off generator
if:
-electrical
output
is lost;
-equipment
sparks, smokes, or emits flames;
-unit vibrates excessively.
I