Télécharger Imprimer la page

BorMann PRO BCD3200 Mode D'emploi page 2

Publicité

EN
SAFETY PRECAUTIONS
Please read the user manual and safety instructions carefully before use to ensure safe and satisfactory use of this product.
Wear hearing protection!
Charger safety
Warning: To reduce the risk of electric shock and damage to the charger and battery, use the lithium batteries listed on the charger to charge the battery. Use
of another type of battery can cause an explosion and cause injury.
1) Before using the charger, carefully read the operating instructions and the warnings on the instructions to avoid the risk of injury due to misuse.
2) Do not use the charger outdoors. Do not expose it to rain or moisture. The risk of electric shock is increased if water enters the machine.
3) Do not use this charger to charge batteries from other manufacturers. Failure to use the device according to the regulations may result in fire or explosion.
4) Do not use the charger outdoors, and keep it away from rain or moisture. The risk of electric shock is increased if water is allowed to penetrate the machine.
5) Do not misuse the charger or the cables. Do not pull the charger by the cord. Do not pull on the cord when disconnecting the charger from the power source.
Doing so may damage the charger and cables and cause an electric shock. Replace cables immediately in the event of damage.
6) Make sure that the wires are placed in a suitable position and do not touch the sharp edges and moving parts, otherwise they will be damaged. This will
reduce the risk of damaging the wires and causing an electric shock.
7) Keep the cable and charger away from high temperatures to prevent damage to the charger's casing and internal parts.
8) Do not allow gasoline, petroleum, etc. to come into contact with plastic parts. These substances contain chemicals that can damage, weaken, or destroy
plastic.
9) It is not necessary to use an extension cord. Using an unsuitable extension cable may cause fire or electric shock. If you must use an extension cable, make
sure that the extension cable is in good condintion and matches the charger socket.
10) Do not use the charger with a damaged cord or socket, as this may cause a short circuit and electric shock. If damaged, return the charger to an authorised
service centre for repair.
11) Do not use the charger if it has been dropped or otherwise damaged. Take the charger to an authorised service centre to check that the charger is intact.
12) Do not disassemble the charger without authorisation. The charger should only be repaired by a qualified electrician. There is a high risk of electric shock
and fire due to incorrect reorganisation.
13) Always unplug the charger from the wall outlet when servicing or cleaning the charger. This will reduce the risk of electric shock.
14) Unplug the charger when it is not in use. This can reduce the risk of electric shock or prevent metal substances from falling into the socket and damaging
the charger.
15) Avoid electric shock. Do not touch uninsulated parts of the socket.
WARNING! The machine may overheat after prolonged use and must be cooled to a suitable temperature before use to avoid damage to the
machine.
SPECIFICATIONS
Technical Data
Model
Voltage
Suction cup diameter
Applicable ceramic tile
Battery
Vibration frequency
Adsorption capacity
Weight
Levers
2
Wear a dust mask!
BCD3200
21 V
128 mm
128 cm
2 x 1.5 Ah
28000 r/min
128 kg
1.6 kg
12
WWW.NIKOLAOUTOOLS.GR
* The manufacturer reserves the right to make minor changes to product design
and technical specifications without prior notice unless these changes significantly
affect the performance and safety of the products. The parts described /
illustrated in the pages of the manual that you hold in your hands may also
concern other models of the manufacturer's product line with similar features and
may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all
repair, inspection or replacement work, including maintenance and special
adjustments, must only be carried out by technicians of the authorized service
department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product
with non-provided equipment may cause malfunctions or even serious injury or
death. The manufacturer and the importer shall not be liable for injuries and
damages resulting from the use of non-conforming equipment.
Wear safety glasses!

Publicité

loading

Ce manuel est également adapté pour:

056393