Publicité
Liens rapides
Owner's Instruction and Operation Manual
Model Number:
VG5713
Report Number: F22-771
Certified to ASTM E1509-2022 and
Certified to CAN/ULC S627:2023
Mobile Home / Transportable Building
Approved
* All Pictures In This Manual Are For Illustrative Purposes Only. Actual Product May Vary.
Save These Instructions In A Safe Place For Future Reference.
SAFETY NOTICE: If this heater is not properly installed, a house fire may result. For
your safety, follow the installation instructions. Never use make-shift compromises
during the installation of this heater. Contact local building or fire officials about
permits, restrictions and installation requirements in your area. NEVER OPERATE THIS
PRODUCT WHILE UNATTENDED.
CAUTION! Please read this entire manual before you install or use your new room
heater. Failure to follow instructions may result in property damage, bodily injury, or
even death. Improper Installation Will Void Your Warranty!
U.S. Environmental Protection Agency
Certified to comply with 2020 particulate
emissions standards.
© 2024 United States Stove Company, 227 Industrial Park Rd., South Pittsburg, TN 37380
R
THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE.
CALIFORNIA PROPOSITION 65 WARNING:
This product can expose you to chemicals
including carbon monoxide, which is known to the
State of California to cause cancer, birth defects,
and/or other reproductive harm. For more
information, go to www.P65warnings.ca.gov
853914E-1706N
Ph. 800-750-2723
Publicité
Manuels Connexes pour United States Stove Company VOGELZANG VG5713
Sommaire des Matières pour United States Stove Company VOGELZANG VG5713
- Page 1 State of California to cause cancer, birth defects, emissions standards. and/or other reproductive harm. For more information, go to www.P65warnings.ca.gov THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE. © 2024 United States Stove Company, 227 Industrial Park Rd., South Pittsburg, TN 37380 Ph. 800-750-2723...
- Page 2 Text to 423-301-5624 or; You can also register your product online at Email us at: www.usstove.com/support/product-registration customerservice@usstove.com / OR by downloading the US Stove Company app available for iOS and Android. © 2024 United States Stove Company...
- Page 3 Declaration of Completion: As the qualified person responsible for the work described above, I confirm that the appliance as associated work has been installed as per manufacturer’s instructions and following any applicable building and installation codes. Signed: _______________________________________ Print Name: ___________________________________ Date: _______________ Home Owner: RETAIN THIS INFORMATION FOR FUTURE REFERENCE © 2024 United States Stove Company...
- Page 4 2. Unpack the top mount controls and ensure that the wiring harness shown is attached securely. 4. Secure the control panel to the top of the stove with two sheet metal screws. © 2024 United States Stove Company...
- Page 5 OR PINCH THE CORD UNDER FURNITURE. WETT (Canada) technician. To find the nearest qualified installer, go to: CAUTION: https://nficertified.org, BURNING FUEL CREATES CARBON MONOXIDE AND CAN BE HAZARDOUS TO YOUR HEALTH IF NOT https://www.wettinc.ca/ PROPERLY VENTED. © 2024 United States Stove Company...
- Page 6 Ceiling to Floor 60” 1524 mm Ceiling to Stove 27.5 699 mm Wall to Stove 7-1/2” 191 mm Side Wall to PL Vent Pipe 11-1/4” 286 mm Wall to PL Vent Pipe 7-1/2” 191 mm © 2024 United States Stove Company...
- Page 7 2, 1/4” lag bolts that • DO NOT INSTALL A FLUE DAMPER IN THE EXHAUST are long enough to go through both a hearth pad, if used, VENTING SYSTEM OF THIS UNIT. and the floor of the home. © 2024 United States Stove Company...
- Page 8 12-feet or if the installation is over 2,500 feet above sea level. We recommend the use of Simpson Dura-Vent® or Metal-Fab® pipe (if you use other pipe, consult your local building codes and/or building © 2024 United States Stove Company...
- Page 9 (3.7m), the pellet vent pipe size should be increased to installation. A support bracket should be placed just below 4” (102 mm) in diameter. the termination cap or one every 4ft (1.22m) to make the © 2024 United States Stove Company...
- Page 10 860001, 3-6” transition into 6” connector pipe (the illustration is only an example). Please conform to any local building codes or regulations having jurisdiction before you have a qualified installer proceed with this installation. © 2024 United States Stove Company...
- Page 11 • The levels of heat output will incrementally change on • When room temperature drops below desired set-point the bar graph starting from heat range “1” to heat range the stove will ramp back up until it reaches the desired “5”. temperature. © 2024 United States Stove Company...
- Page 12 3. Materials containing rubber, including tires; all warranties. The design incorporates automatic feed of the pellet fuel into the fire at a carefully prescribed rate. Any 4. Materials containing plastic; © 2024 United States Stove Company...
- Page 13 NOTE: During the first few fires, your stove will emit an odor The damper control lever is located on the back of the as the high-temperature paint cures or becomes seasoned stove on the lower left side. The default setting for the © 2024 United States Stove Company...
- Page 14 The • DO NOT OVERFILL HOPPER. manufacturer recommends that you call customer service if this occurs as this may indicate a more serious problem. A service call may be required. © 2024 United States Stove Company...
- Page 15 The clean outs Plate are secured to the firebox with (2) 5/16” screws. Remove the clean outs and vacuum out any accumulated ash. This should be done at least once per month or more © 2024 United States Stove Company...
- Page 16 We recommend using a high quality glass cleaner. Should The container shall not be used for other trash or waste a buildup of creosote or carbon accumulate, you may wish © 2024 United States Stove Company...
- Page 17 Inspected they are free of animal hair build up. Animal hair build up Glass Wiped Cleaned in blowers can result in poor performance or unforeseen Hopper (end of Empty & safety hazards. season) Vacuumed © 2024 United States Stove Company...
- Page 18 DO NOT INSTALL IN AN ALCOVE 200 mm (8 in) beyond the appliance on other sides, shall DO NOT INSTALL IN ANY FIREPLACE be protected by a continuous, durable, non-combustible © 2024 United States Stove Company...
- Page 19 If the other items check out OK, replace the high limit switch. ATTENTION: THIS WOOD HEATER NEEDS PERIODIC INSPECTION AND REPAIR FOR PROPER OPERATION. IT IS AGAINST FEDERAL REGULATIONS TO OPERATE THIS WOOD HEATER IN A MANNER INCONSISTENT WITH OPERATING INSTRUCTIONS IN THIS MANUAL. © 2024 United States Stove Company...
- Page 20 If you hear a click, the air switch is working. BE CAREFUL TOO MUCH VACUUM CAN DAMAGE THE AIR SWITCH. © 2024 United States Stove Company...
- Page 21 The control board is not sending power to the POF There should be a 5-volt (approximately) current going to the POF thermodisc or other auger system components. thermodisc after the stove has been on for 10 minutes. © 2024 United States Stove Company...
- Page 22 Remove the auger motor from the auger shaft and try to run the The auger motor has failed. unit. If the motor will turn the shaft is jammed on something. If the motor will not turn, the motor is bad. © 2024 United States Stove Company...
- Page 23 Circuit board malfunction. is fine. If there is NOT power being sent to the blower when it shuts off during operation, then you have a bad control board. © 2024 United States Stove Company...
- Page 24 Check to see if a surge protector is being used on the stove. If not, recommend one to the consumer. High limit switch is malfunctioning. If the other items check out okay, replace the high limit switch. © 2024 United States Stove Company...
- Page 25 Bad Pellets. (Applies to GLASS “SOOT’S” UP AT A might also want to try a brand that is made from a different type VERY FAST RATE Only) of wood (softwood vs. hardwood). Different woods have different characteristics when being burned. © 2024 United States Stove Company...
- Page 26 80455 High Temp Snapdisc Air IN ORDER TO MAINTAIN WARRANTY, COMPONENTS MUST BE REPLACED USING ASHLEY PARTS PURCHASED THROUGH YOUR DEALER OR DIRECTLY FROM ASHLEY. USE OF THIRD PARTY COMPONENTS WILL VOID THE WARRANTY. © 2024 United States Stove Company...
- Page 27 WIRING DIAGRAM 7.5A 250V FUSE 1.25A 250V FUSE Ensure the wires are connected to the bottom two prongs of the hopper switch as shown. CORRECT WRONG © 2024 United States Stove Company...
- Page 28 NOTES © 2024 United States Stove Company...
- Page 29 Engineer Name: _____________________________________ Engineer Name: _____________________________________ License No.: ________________________________________ License No.: ________________________________________ Company: ___________________________________________ Company: ___________________________________________ Telephone No.: ______________________________________ Telephone No.: ______________________________________ Stove Inspected: Chimney Swept: Stove Inspected: Chimney Swept: Items Replaced: _____________________________________ Items Replaced: _____________________________________ © 2024 United States Stove Company...