EINHELL GC-SCA 18/280 BL Instructions D'origine page 25

Proceed as follows to change the scarifi er roller or
the aerator roller:
Remove the two socket head screws (Fig. 15 /
Item D). Lift the roller at this end (Fig. 16) and pull
it out in the direction of the arrow. If the holder
(Fig. 17 / Item E) does not exist on the roller you
want to install, remove it from the previously used
roller and fi t it on the roller you now want to use.
Slide the new roller in the direction of the arrow
(Fig. 19) onto the square-ended drive (Fig. 18 /
Item F) and then press it into the holder (Fig. 19).
Use the two socket head screws (Fig. 15 / Item D)
to secure the roller again.
Apply grease to the square-ended drive from time
to time so that the rollers can be changed easily.
7.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
Replacement cutting unit Art. No.: 34.059.42
Aerator roller Art. No.: 34.059.41
Catch basket Art. No.: 34.059.40
8. Storage and transport
Important! Remove the battery.
Storage
Store the equipment and accessories out of
children's reach in a dark and dry place at above
freezing temperature. The ideal storage tempera-
ture is between 5 and 30°C. Store the equipment
in its original packaging.
Transport
•
Switch the machine off and pull out the safety
plug before transporting it.
•
Fit transport guards if available.
•
For easier transport and/or storage, open
the wing nuts (Fig. 1 / Item 13) far enough to
allow the push bars to be flipped together at
these points. Take care not to damage the
cable and the push bar tubes.
•
Protect the machine from damage and the
strong vibrations that can occur particularly
when transporting in vehicles.
Anl_GC_SCA_18_280_BL_SPK13.indb 25 Anl_GC_SCA_18_280_BL_SPK13.indb 25
GB
•
Secure the machine against slipping and
tipping over.
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
- 25 -
14.02.2023 07:41:43 14.02.2023 07:41:43