Publicité
Les langues disponibles
Les langues disponibles
Connect the device to the electrical system
Connect the three wires according to the following diagram.
CAUTION!
Only use the cable supplied. DO NOT use third-party
cables or adapters.
Do not make any different connections (for ex.
connections with 1 or 2 wires). This would compromise the
operation of the device and can cause fines.
DO NOT short-circuit the three wires.
Comply with the cable specifications and the vehicle
manufacturer's instructions.
Make sure that the fuses are easy to access and
replaceable.
DO NOT connect the device to the electronic control units
(ECU).
Check the connections
1.
Check that the connector is firmly inserted in the power
supply socket.
2.
Switch on the panel: the green LED status light will switch
on. If there is a fault, the red LED status light will flash or
remain on.
3.
Switch off the panel: the green LED status light flashes
three times and then switches off.
For further information on the LEDs and any messages, see the
enclosed User manual.
Telepass SpA - Via Laurentina, 449 - 00142 Rome (RM) - Italy - www.telepass.com
TLP-K1-Inst-1.1_A4_EN-0123 © 2023
Check the installation with the Self Test Tool
Before using the device for travel, it is necessary to check that it
has been installed and configured correctly. Proceed as follows:
1.
Connect to the installation portal at :
lumesia1.telepass.com/
2.
If you are already registered, enter your username and
password.
3.
If you have not registered yet, enter your cell phone
number and email address, then follow the wizard.
4.
If useful, download the manual and watch the video that
describes how to install and monitor the device.
5.
Follow the wizard to install the device. In this procedure, it
is necessary to enter the device ID code (OBU ID) and the
plate number for the vehicle on which it is installed: the
device is configured automatically.
At the end of the procedure, a correct configuration notification
is sent. In the event of an error, repeat the wizard.
Do not use the device for e-tolls until configuration has been
completed correctly.
Configure the device
Before using, the e-toll device must be set up and the number
of axles and vehicle weight must be set. Please refer to User
manual.
https://self-test-tool-
.
Publicité
