TELEPASS SAT K1 Notice D'installation page 5

DEVICE INSTALLATION
Position on the windshield
Install in the windshield area as indicated below:
- within a 20 cm band, 10 cm over the idle windshield wiper line
- between the windshield median line and center of the steering
wheel.
To identify the shielded windshield zones, please refer to the
vehicle documentation.
NOTICE: make sure that the device does not interfere with the
driver's field of vision when driving and that it is not within the
airbag's range of action.
Installation warnings
NOTICE:
The fixed installation of the device can only be performed at
l
authorized workshops by suitably qualified personnel.
Comply with the power cable specifications, the device
l
power limits and the vehicle manufacturer's instructions.
To ensure the Velcro strip adhesion, install the unit when the
l
ambient temperature is between 20 °C and 40 °C.
Before installing the device, check that all data included in
l
the vehicle declaration are correct. Otherwise, ask the
vehicle's owner for an updated declaration.
Make sure that device installation does not inhibit the
l
correct operations of the vehicle and electrical devices
connected to the electrical system (e.g. tachographs, etc.)
Make sure that the power cable is not subject to mechanical,
l
heat or chemical stress and does not hinder the driver when
driving.
Required material
Two 3 A fuses and relevant fuse boxes.
Telepass SpA - Via Laurentina, 449 - 00142 Rome (RM) - Italy - www.telepass.com
TLP-K1-Inst-1.1_A4_EN-0123 © 2023
Position the device on the windshield
NOTICE: make sure that the power cable is not subject to
mechanical, thermal or chemical stress.
1. Clean the application
area on the
windshield carefully,
using a multipurpose
detergent.
2. Remove the
protective film from
the sticker.
3. Place the device
horizontally on the
clean windshield.
4. Check for air bubbles
in the adhesive area.
Press firmly the device
against the
windshield.
5. Press the connector
fully into the power
socket.