Brandt BFV 1508 Mode D'emploi page 4

Installation
Transit bars
Before the washing machine is operated,
the transit bars at the reverse of the wash-
ing machine must be removed (D. The
three screws must be removed together
with the distance sleeves. Using a span-
pull them and their distance sleeves
Store these parts in a safe place as they
will be required if the washing machine is
to be transported again in the future
The holes where the screws have been
can be concealed using the plastic caps
supplied.
Alignment
a surface which is level and stable. A
slightly uneven surface can be compen-
washing machine @. To adjust, loosen the
key, align
the washing machine feet and tighten the
level).
to any water supply without a non-return
must be screwed onto a tap with a
%"
inch B.S.R thread (©. The water pressure
If the water pressure is higher than this, a
connection support on the
rear of the
washing machine.
sure) and check that the connection point
on the tap and on the washing machine is
the seal and screw connection. Advice on
how to extend the length of the hose can
department.
Water removal
The water which is pumped away must be
able to flow away freely. In order to allow
this, there must be no bends in the hose
higher than 100 cm above the floor level.
It is possible to connect it to a syphon. If
the water is to drain into a wash basin/
sink, the outlet hose must be fitted using
the hose holder supplied @ (pull the hose
it from falling down and to ensure that
the level of the water which is being
5